Repeat this process to add up to 10 fingerprints in total.You can now add an additional fingerprint using the same method as the first fingerprint by following the steps on the previous page in step 2.The light will then begin to blink blue rapidly.Then scan the finger you used the first time setting up the lock which is now the administrator’s fingerprint.Press and hold the fingerprint collection window for 5 seconds until light shows blue solid and then take your finger off.If the lock shows a red light during set up your fingerprint failed to scan and you will need to restart the process.ĭuring the setup process, if you wait 15 seconds while the light is blinking blue without touching the fingerprint scanner, the setup process will time out and you will have to start at step 1 again. (Usually about 5 times)The green light means it registered your fingerprint successfully and you may now start using your fingerprint lock with the fingerprint you set in the lock. Use the finger you want to add the fingerprint off and place it on and off the collection window repeatedly until you see the green light.Press and hold the fingerprint collection window for 5 seconds until the light blinks blue rapidly and then take your finger off.Level: Contact Type +4K, Air discharge +8Kįingerprint identification rate: <0.0001% Indication of States/Mode: 3 color LEDs + Buzzer Press times for fingerprint entry: 10 times
Brookstone multiclock manual how to#
Lock design and functionality is easy to learn how to use.įingerprint Lock, User Manual, and USB cable. ©Smartpoint LLC, 250 Liberty Street, Suite 1A Metuchen, NJ 08840 PRODUCT CONFIGURATION
Brookstone multiclock manual license#
All rights reserved Manufactured, marketed, and distributed by Smartpoint LLC, under license All Trademarks and Registered Trademarks are property of their respective owners Made in China names and logos are owned by BKST Brand Holdings LLC ©2021. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.įor more products please visit WARRANTY INFORMATION This device complies with Part 15 of the FCC Rules.
– Consult the dealer or an experienced radio/TV technician for helpĬhanges or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Increase the separation between the equipment and receiver. – Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Operation is This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
0 kommentar(er)
